A/C Compressor Drive Seal, Replacing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Seal Installer - A/C Compressor :T40192
Puller - Shaft Seal :T40195

-- Remove the A/C compressor. Refer to A/C COMPRESSOR .

-- Remove the hose clamp on the dust cap -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the dust cap and A/C compressor drive axle from the end of the spur gear shaft for the A/C compressor drive.

-- Rotate the spindle on the :T40195 all the way back.

Courtesy of AUDI OF AMERICA, LLC

-- Lubricate the seal remover threaded head, position it, and then install it into the shaft seal as far as possible using strong force.

-- Rotate the inner section of the seal puller against the spur gear unit until the shaft seal is removed.

NOTE:

If the shaft seal breaks, position the seal puller a second time and remove the rest of the seal.

-- Clamp the seal puller in a vise at the hex bolt and remove the shaft seal with pliers.

-- Clean the running and sealing surface.

-- Drive in the A/C compressor drive axle seal with the :T40192 .

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Use a hose clamp appropriate for the model.

Courtesy of AUDI OF AMERICA, LLC

-- Slide the dust cap -arrow- with pre-installed hose clamp on the end of the spur gear shaft for the A/C compressor drive.

-- Install the A/C compressor. Refer to A/C COMPRESSOR .