LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Engine System (Crankshaft & Cylinder Block - Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC)) >> Crankshaft, Cylinder Block >> Piston And Connecting Rod >> Pistons, Removing And Installing >> Installing

Pistons, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace any bolts that were tightened with an additional turn.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston using a commercially available piston ring compressor.

Installed position:

-- Install the connecting rod bearing cap according to the marking.

-- Install the baffle plate. Refer to figure in Baffle Plate Tightening Specifications .

-- Install the oil pump. Refer to OIL PUMP, REMOVING AND INSTALLING

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Install the cylinder head. Refer to CYLINDER HEAD, INSTALLING .

scientia non olet · About LEMON Manuals