LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Engine System (Crankshaft & Cylinder Block - Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC)) >> Crankshaft, Cylinder Block >> Cylinder Block, Transmission Side >> Drive Plate, Removing And Installing >> Removing

Drive Plate, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

-- Insert the :10-201  to loosen the bolts.

GWWA13-10911Courtesy of AUDI OF AMERICA, LLC
CAUTION:

The outer surface of the bearing flange at the drive plate could be damaged.

  • Use a multipoint socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.

-- Remove the bolts and remove the drive plate.

-- Remove the Engine Speed Sensor -G28- sensor wheel

scientia non olet · About LEMON Manuals