Ribbed Belt, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Route the ribbed belt -2- in the specified sequence over the ribbed belt pulley.
1 - Generator
3 - Idler roller
4 - Vibration damper
5 - Tensioner
NOTE:
When installing the ribbed belt, make sure it is seated correctly on the pulleys.
-- Start the engine and check the belt routing.
-- Install the front bumper cover end plate. Refer to BUMPER COVER .