Overview - Ribbed Belt Drive: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 55 Nm
- Bolt
- 22 Nm
- Tensioner
- For the ribbed belt
- Removing and installing. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .
- Ribbed Belt
- Check for wear
- Before removing, mark the direction of rotation using chalk or a felt-tip pen.
- Removing and installing. Refer to RIBBED BELT, REMOVING AND INSTALLING .
- Do not kink
- When installing, make sure it is seated correctly on the ribbed belt pulleys
- Cap
- For the idler roller
- Bolt
- Tightening specification. Refer to OVERVIEW - GENERATOR .
- Generator
- Removing and installing. Refer to GENERATOR, REMOVING AND INSTALLING .
- Bolt
- 22 Nm
- Idler Roller
- For the ribbed belt
- With bolt -8-
- Vibration Damper
- With ribbed belt pulley
- Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to figure in Tightening Specifications .
- Always replace