LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Engine System (Crankshaft & Cylinder Block - Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC)) >> Crankshaft, Cylinder Block >> Crankshaft >> Sensor Wheel, Removing And Installing >> Installing

Sensor Wheel, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- The "combustion misfire adaptation" must be adjusted after replacing the transmission. Select 01 - Reset Combustion Misfire Adaptation  in Guided Fault Finding  see Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals