Sealant Applied On Cylinder Block For Guide Frame
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
-- Clean any oil or grease off the sealing surfaces.
CAUTION:
The lubrication system could be plugged with excess sealant.
- Do not apply sealant beads thicker than indicated.
-- Apply sealant beads -arrows- to the clean sealing surfaces as shown in the illustration.
- Thickness of sealant beads: 2.0 mm.
-- Place the seals -1, 2 and 4- and O-ring -3-.
NOTE:
The guide frame must be installed within 5 minutes after applying the sealant.