Cylinder Bank 1 (Right):

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

-- Attach both of the camshaft adjusters without camshaft timing chains to the cylinder head and then loosely screw on the bolts -1 and 2-.

-- Position the :T40269 onto the camshaft adjuster for the right exhaust camshaft and counterhold with a wrench -2-.

-- Tighten the bolt -1- by hand.

-- Turn the exhaust camshaft with the wrench clockwise until the thread for the camshaft clamp is in the lower center of the camshaft housing opening.

-- Tighten the left bolt -left arrow- on the :T40264/1 .

-- Position the :T40269 onto the camshaft adjuster for the right intake camshaft and counterhold with a wrench -2-.

-- Tighten the bolt -1- by hand.

-- Turn the intake camshaft with the wrench clockwise until the thread for the camshaft clamp is in the lower center of the camshaft housing opening.

-- Tighten the right bolt -right arrow- on the :T40264/1 .

-- Counterhold with the wrench while removing the bolts -1 and 2- and then remove the camshaft adjuster.