Camshaft, Measuring Axial Clearance
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Dial Gauge Holder :VW387
- Dial Gauge - 0-10 mm :VAS6079
-- Remove the camshaft housing. Refer to CAMSHAFT, REMOVING AND INSTALLING .
-- Place the camshaft to be checked into the camshaft housing.
-- Secure the :VAS6079 with the :VW387 on the camshaft housing.
-- Press the camshaft against the dial gauge by hand.
-- Set dial gauge to "0".
-- Press camshaft off dial gauge and read the value:
- Axial clearance: 0.100 to 0.191 mm.