LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine System (Cylinder Head & VALVETRAIN - Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC)) >> Cylinder Head, VALVETRAIN >> Timing Chain Cover >> Timing Chain Cover, Removing And Installing >> Right Timing Chain Cover, Removing And Installing >> Removing

Right Timing Chain Cover, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the vacuum pump. Refer to HYDRAULIC SYSTEM .

-- Remove the bolts -1 and 2-.

GWWA19-11417
CAUTION:

Danger of causing damage to the coolant pipe.

  • Do not bend the coolant pipe.

-- Remove the rear upper coolant pipe from the right cover for the timing chain guard in direction of -arrow- and set it aside.

NOTE:

The catalytic converter and the turbocharger support are removed to improve the clarity of the illustration.

Ignore item -2-.

-- Open the clamp -1- and remove the coolant hose.

GWWA10-11541

-- Disconnect the connectors -1 and 2-.

-- Remove the bolts -arrows- and move the mount -3- and wiring harness to the side.

GWWA15-11259

-- Remove the bolts in the following sequence: -8 to 1- counter-clockwise as shown.

GWWA15-11217

-- Carefully remove the right cover for the timing chain from the bond.

scientia non olet · About LEMON Manuals