LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine System (Cylinder Head & VALVETRAIN - Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC)) >> Cylinder Head, VALVETRAIN >> Cylinder Head >> Cylinder Head, Removing And Installing >> Cylinder Head, Installing >> Continued for Both Sides

Continued for Both Sides

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order of removal, while noting the following:

-- Install the engine support and the right engine mount. Refer to RIGHT ENGINE MOUNT, REMOVING AND INSTALLING .

-- Install the wires. Refer to RELAY CARRIERS, FUSE PANELS AND E-BOXES and the Appropriate Wiring Diagram.

-- Install the front bumper cover. Refer to FRONT BUMPER .

-- Install the left front Knock Sensor 3 -G198-. Refer to Knock Sensor 3 -G198-, REMOVING AND INSTALLING .

-- Install the camshafts. Refer to CAMSHAFT, REMOVING AND INSTALLING .

-- Install the turbocharger. Refer to TURBOCHARGER, REMOVING AND INSTALLING .

-- Change the engine oil.

-- Replace the coolant. Refer to COOLANT, DRAINING AND FILLING .

scientia non olet · About LEMON Manuals