Cylinder Head Bank 2 (Left), Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Engine Support Bridge :10-222A
- Engine Support - Bracket w/Spindle and Hook :10-222A/10
- Engine Crane Adapter - Bracket :T10013
- Threaded pin of Engine Support Bracket :T10338
- Engine Support - Basic Set :T40091
- Engine Support - Supplement Kit :T40093A with :T40093/7 , and :T40093/8
- Commercially available XZN M12 socket, minimum 75 mm long
- Sealant.
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Cylinder Head to Cylinder Block
- O-ring - Front Coolant Pipe to Cylinder Head
- Cylinder Head Gasket - Cylinder Head to Cylinder Block