Camshaft Timing Chain TENSIONER, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If the tensioning element was removed from the chain tensioner, then the installation position must be noted: Hole in housing floor faces toward chain tensioner, piston faces toward tensioning rail.

Replace any bolts that were tightened with an additional turn.

-- Press the tensioning rails for the left or right camshaft timing chain tensioner inward in direction of -arrow- as far as the stop and secure the chain tensioner with a :T40071 .

-- Insert the chain tensioner at the left cylinder head and install the camshaft timing chain as shown in the illustration.

-- Tighten the bolts -1 and 2-.

-- Insert the chain tensioner at the right cylinder head and install the camshaft timing chain as shown in the illustration.

-- Tighten the bolts -1 and 2-.

Installation is performed in reverse order of removal, while noting the following:

-- Position the camshaft timing chain on the camshafts. Refer to CAMSHAFT TIMING CHAIN, REMOVING FROM CAMSHAFTS .