LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 111 (Transmission Controls System (Service Information - 7-Speed Dual Clutch - 0B5)) >> 34 Controls, Housing >> Transmission, Disassembling And Assembling >> Sensor Module --, WITH INTEGRATED TRANSMITTERS AND SENSORS -G612-, -G632-, -G676 - AND Circuit Board 3 --, REMOVING AND INSTALLING >> Notes

Sensor Module --, WITH INTEGRATED TRANSMITTERS AND SENSORS -G612-, -G632-, -G676 - AND Circuit Board 3 --, REMOVING AND INSTALLING: Notes

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Do not use the Hook And Support Tool T40197 for the following described work procedures - There is a risk of injury.

Only use the Hook and Support Tool T40294 for this operation.

Special tools and workshop equipment required 

NOTE:

The Transmission Input Speed Sensor 2 -G612-, Transmission Input Speed Sensor 1 -G632-, Drive Position Sensor -G676- and Circuit Board 3 -- are integrated in the Sensor Module --. The components can only be replaced as a single Sensor Module -- unit.

Replace the wiring set for the sensor module when replacing the Sensor Module --. Refer to -item  39 .

scientia non olet · About LEMON Manuals