Oil Pump And Suction Jet Pump, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Secure the transmission on the Engine And Transmission Holder :VAS6095 . Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .
-- Remove the flywheel. Refer to FLYWHEEL, REMOVING AND INSTALLING .
-- Remove the dual clutch. Refer to DSG CLUTCH, REMOVING .
-- Remove the DSG Transmission Mechatronic -J743-. Refer to MECHATRONIC, REMOVING AND INSTALLING .
-- Wrap the splines for the outer drive axle with adhesive tape in direction of -arrow-, so that the inner surfaces of the suction jet pump are not damaged when removing or installing.
-- Coat the tape lightly with grease.
-- Remove the bolts -arrows- and push the oil pump forward on the input shaft.
-- Remove the bolts -arrows- for the suction jet pump -2- on the back of the oil pump -1-.
NOTE:
The oil pump is shown removed.
-- Remove the oil pump and suction jet pump separately from the input shaft.