Oil Pan, Removing And Installing: Removing

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

General Repair Instructions. Refer to REPAIR INFORMATION .

Rules for cleanliness when working on the DSG transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

The Transmission is Installed

It is also possible to remove and install the ATF pan when the transmission is installed. Depending on the vehicle model and the engine version, additional work may be required to be able to reach the ATF pan. Refer to Mechatronic , or MECHATRONIC

Transmission Removed

-- The transmission is secured to the engine/transmission holder. Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .

-- Place the Used Oil Collection and Extraction Unit :SMN372500 under the transmission.

-- Drain the ATF. Refer to ATF, DRAINING AND FILLING .

-- Diagonally Loosen the screws -1 through 15-.

Fig 1: ATF Pan Loosening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts and the ATF pan.

NOTE:

Ignore -arrows-.