Fastener Tightening Specifications: Notes
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
| Components | Fastener Size | Tightening Specifications |
|---|---|---|
| Bolts and Nuts | M6 | 9 Nm |
| M6 | 15 Nm | |
| M8 | 20 Nm | |
| M10 | 40 Nm | |
| M12 | 65 Nm | |
| Air guide to transmission | - | 3 Nm |
| Cable mounting bracket to transmission | - | 8 Nm |
| Securing shift mechanism to the body, nut | - | 8 Nm |
| Selector lever cable adjustment | - | 13 Nm |
| Stop to transmission mount (1) | - | 20 Nm + 90° |
| Tunnel crossmember to transmission | - | 70 Nm |
| Tunnel crossmember to transmission mount nut | - | 20 Nm |
| Transmission support to transmission | - | 40 Nm |
| Transmission support to transmission mount nut/bolt | - | 20 Nm |
| ATF Cooler to bracket | - | 9 Nm |
| Cover to ATF housing | - | 8 Nm |
| Cover to transmission | - | 20 Nm |
| ATF filter Housing to transmission | - | 10 Nm |
| ATF Pipe/Hose Line to ATF filter Housing (2) | - | 8 Nm |
| - | 20 Nm | |
|
||
Drive Axle Heat Shield - Tightening Specification
-- Tighten the heat shield bolts -arrows- to 23 Nm.