Shift Lock Solenoid -N110-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Turn the ball rod -1- into the correct installed position.
-- Install the Shift Lock Solenoid -N110- at an angle into the selector mechanism and then tilt it in the opposite direction of -arrow-.
- The ball rod -1- must engage completely in the operating lever on shift mechanism. Press it down using a small screwdriver if necessary.
-- Attach the Shift Lock Solenoid -N110- to the hook -A-.
-- Position the cover -A- over the Shift Lock Solenoid -N110- and carefully lock it in -1 through 3-.
-- Connect the electrical connectors.
-- Check the shift mechanism function before completing assembly. Refer to GEARSHIFT MECHANISM, CHECKING .
-- Install the front ashtray or storage compartment. Refer to CENTER CONSOLE .