Selector Lever Cable, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the lock washers for the noise insulation.

Lubricate the cable eye and the ball socket on the selector lever cable with Polycarbamide Grease :G 052 142 A2 before installing.

-- Insert the O-ring -1- on the selector lever cable.

Courtesy of AUDI OF AMERICA, LLC

-- Install the selector lever cable -2- into the gearshift mechanism function unit in direction of -arrow-.

-- Secure the selector lever cable -2- with the clip -3-.

Installed position: The angled end of the clip -1- faces the shift mechanism.

Courtesy of AUDI OF AMERICA, LLC

-- Push the selector lever -1- on the transmission all the way to the back in direction of -arrow- until the parking lock locks into place.

Courtesy of AUDI OF AMERICA, LLC

When parking lock is engaged, it must not be possible to turn the front wheels.

-- Press the selector shaft lever forward three detents so the transmission is in "D".

-- Make sure the selector lever inside the vehicle is also in "D".

-- Carefully press the selector lever cable ball socket -2- in this position onto the selector shaft lever.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Do not bend selector shaft lever when pressing on, otherwise shift mechanism can no longer be adjusted exactly.

-- Secure the selector lever cable with the clip -1-.

-- Depending on the version a lock nut can be installed instead of a clip -1-, tightening specification 13 Nm.

NOTE:

Do not bend or kink the selector lever cable.

-- Check the selector mechanism. Refer to GEARSHIFT MECHANISM, CHECKING .

-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .