LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Transmission Controls System (Service & Specification Information - 7-Speed Dual Clutch - 0B5)) >> 34 Controls, Housing >> Selector Mechanism >> Overview - Selector Lever Cable

Overview - Selector Lever Cable

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
GWWA34-10424Courtesy of AUDI OF AMERICA, LLC
  1. Clip
    • For the selector lever cable on the selector mechanism function unit
  2. O-ring
    • Always replace
  3. Bolt
    • 13 Nm
    • For selector lever cable adjustment
  4. Selector Lever Cable
    • Do not bend
    • Different versions depending on the vehicle.
    • Removing and installing. Refer to SELECTOR LEVER CABLE, REMOVING AND INSTALLING .
    • The selector lever cable must be replaced if the rubber grommet is damaged.
    • Lubricate the ball socket lightly with Polycarbamide Grease :G 052 142 A2  before installing.
    • Make sure the rubber grommet on the transmission side is not twisted when installing.
    • Adjusting. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .
      • Perform "Guided Functions"  using the Vehicle Diagnostic Tester after adjusting the selector lever cable. Refer to TRANSMISSION GUIDED FUNCTIONS .
  5. Selector Lever
  6. Clip
    • Lock nut 13 Nm depending on the version
    • For attaching the selector lever cable to the cable bracket
  7. Cable Mounting Bracket
  8. Bolt
    • 8 Nm
  9. Bolt
    • 8 Nm
scientia non olet · About LEMON Manuals