ATF Oil Pan, Tightening Specification and Sequence
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Loosening and tightening is the same.
Tighten the bolts in two stages as described below.
- Install the bolts -arrows- hand-tight.
- Tighten the screws -1 through 15- diagonally to 10 Nm and in steps.
-- Install the right coolant pipe on the transmission. Refer to COOLANT PIPES[For engine(s) CTGE, CWUC] , or COOLANT PIPES [For engine(s) CPNB] , or COOLANT PIPES [For engine(s) CREC, CREH] , or COOLING SYSTEM/COOLANT .
-- Fill the ATF. Refer to ATF LEVEL, CHECKING .