MECHATRONIC, Removing And Installing: Removing

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

The transmission is installed.

CAUTION:

Danger of causing damage to the transmission.

Do not start the engine if there is no ATF in the transmission or if the S tronic transmission Mechatronic -J743- is removed.

NOTE:

General Repair Instructions. Refer to GENERAL REPAIR INFORMATION .

Rules for cleanliness when working on the S tronic transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

S tronic Transmission 0B5 Information. Refer to GENERAL INFORMATION .

-- Move the selector lever into "P".

-- Turn off the ignition and remove the key.

-- Remove the nuts -1- and the bolt -2- and then remove the heat shield.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There is a risk of destroying the transmission control module (Mechatronic) with static discharge.

Always "discharge" the static electricity before working with electric connectors. Do this by touching a grounded object, for example vehicle ground, the vehicle or the hoist.
Do not touch contacts in transmission connector with hands.

-- Turn the twist lock counter-clockwise -arrow- and disconnect the connector from the transmission.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ATF filter housing. Refer to ATF FILTER HOUSING, REMOVING AND INSTALLING .

Description of additional procedures. Refer to MECHATRONIC , or Mechatronic .