MECHATRONIC, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

CAUTION:

There is a risk of destroying the transmission control module (Mechatronic) with static discharge.

Always "discharge" the static electricity before working with electric connectors. Do this by touching a grounded object, for example vehicle ground, the vehicle or the hoist.
Do not touch contacts in transmission connector with hands.

-- Make sure the connector is correctly connected to the Mechatronic.

-- Install the ATF filter housing. Refer to ATF FILTER HOUSING, REMOVING AND INSTALLING .

-- Install the ATF pan. Refer to OIL PAN, REMOVING AND INSTALLING .

-- Fill the ATF. Refer to ATF LEVEL, CHECKING .

After replacing the S tronic Transmission Mechatronic -J743-, the corresponding "Guided Functions" must be performed with the Vehicle Diagnostic Tester. Refer to TRANSMISSION GUIDED FUNCTIONS .