ATF Pipes, Removing And Installing: Removing

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Rules for cleanliness when working on the S tronic transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Remove the rear noise insulation -2-. Refer to NOISE INSULATION .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -1- and the bolt -2- and then remove the heat shield.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and then remove the side cover -1- from the transmission.

Courtesy of AUDI OF AMERICA, LLC

-- Place the :SMN372500 under the separating points.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and then remove the ATF hose lines.

-- Seal the open lines and connections with clean plugs from the :VAS6122 .

-- Remove the ATF pipe/hose line.