ATF Pipes, Removing And Installing: Installing: Clean
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Rules for cleanliness when working on the S tronic transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
Always clean the oil lines and oil cooler before installing a new transmission.
WARNING:
Danger of eye injury.
- Wear protective eyewear.
-- Place the :SMN372500 under the separating points.
-- Remove the bolts -arrows- and then remove the ATF hose lines.
-- Clean the ATF cooler and the ATF pipe/hose lines use compressed air (maximum 10 bar (145 psi)).
-- Install in reverse order of removal. Refer to ATF PIPES, REMOVING AND INSTALLING
NOTE:
If extremely dirty ATF flows out when cleaning using compressed air, flush the ATF cooler and the ATF pipe/hose line using clean ATF.