LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Transmission Controls System (Service & Specification Information - 7-Speed Dual Clutch - 0B5)) >> 34 Controls, Housing >> ATF Circuit >> ATF Cooler, Removing And Installing >> Installing

ATF Cooler, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Danger of leaks!

  • Always replace the seals on the oil lines and the filter housing and coat with ATF.
  • Ensure a clean sealing surface.
CAUTION:

Danger of causing damage to the transmission.

  • When disassembling, remove all the plugs, which were taken from the :VAS6122  , and the ATF pipe/hose line and from the transmission.
  • The ATF cooling function will not work and the transmission will be damaged if the plugs are forgotten.

Install in reverse order of removal. Note the following:

-- Fill the engine coolant. Refer to COOLANT, DRAINING AND FILLING [For engine(s) CTGE, CWUC] , or COOLANT, DRAINING AND FILLING [For engine(s) CPNB] , or COOLANT, DRAINING AND FILLING [For engine(s) CREC, CREH] , or COOLING SYSTEM/COOLANT .

scientia non olet · About LEMON Manuals