LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Suspension, Wheels & Steering - General & Technical Data) >> 00 General, Technical Data >> Repair Information >> Threshold "A" In Mm

Threshold "A" In Mm

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If the readout value is greater than the limit value "a" (table value): Damping effect insufficient, replace shock absorber.

If the readout value is less than the limit value "a" (table value): Damping effect sufficient → Shock absorber does not need to be replaced.

Sportback 

Vehicle Type Front Axle Rear Axle Comment
Standard suspension air suspension 1BK with 17 inch and 18 inch tires (1) 42 52 no load tank full
Standard suspension air suspension 1BK with 19 inch and 20 inch tires (1) 40 40 no load tank full
Sport suspension air suspension 2MB in work in work no load tank full
Standard suspension 1BA 46 46 no load tank full
Sport suspension 1BE 40 40 no load tank full
Heavy duty suspension 1BB in work in work no load tank full
Sport suspension 1BV 40 40 no load tank full
(1) The vehicle is set to >>standard vehicle height<< ; it is not permitted to perform the measurement when the vehicle is set to >>dynamic<< and with the vehicle lifted in >>highest level<<.

The tires must be "partially loaded" when measuring the tire pressure.