Drive Axle General Information
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
The wheel bearing must not be under a load while the drive axle threaded connection on the wheel side is loose.
If the bearings are loaded by the vehicle weight the wheel bearing will be damaged. This reduces the service life of the wheel bearings. Therefore observe the following:
- Procedure for loosening drive axle to wheel hub bolted connection, refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
Vehicles without a drive axle must not be moved, otherwise the wheel bearing will be damaged. If the vehicle does have to be moved, always note the following points:
-- Install an outer joint in place of the drive axle.
-- Tighten the outer joint to 200 Nm.
Do not let the drive axle hang down. The inner joint could be damaged if it is bent too far.