Differential Pressure Sensor -G505-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2016 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Disconnect the connector -3-.
-- Unclip and remove the Differential Pressure Sensor -G505- -2- from the bracket.
-- If the pressure sensor hose is to be removed, if applicable, open the hose clamps and spray the hose with silicone-free lubricant.
-- To prevent the connection from breaking off, carefully pull the hose straight off the connection to remove.