LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Fuel Injection System (Diesel - General & Service Information - TDI 3.0L - CPNB)) >> 23 Diesel Fuel Injection >> Fuel Injection System >> Fuel Injection System, Component Location Overview >> Engine Front, Components Location Overview

Engine Front, Components Location Overview

WARNING: This page is about a different car, the 2016 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fuel Injection System Components Location - Engine Front 

GWWA23-10562Courtesy of AUDI OF AMERICA, LLC
  1. Oil Level Thermal Sensor -G266-
  2. Map Controlled Engine Cooling Thermostat -F265-
  3. Oil Temperature Sensor 2 -G664-
  4. Oil Pressure Switch -F22-
  5. Reduced Oil Pressure Switch -F378-
  6. EGR Cooler Switch-Over Valve -N345-
  7. Intake Flap Motor -V157-
  8. Throttle Valve Control Module -J338-
  9. Engine Temperature Control Sensor -G694-
  10. Oil Pressure Regulation Valve -N428-
  1. Fuel Pump Control Module -J538-
    • Component location, refer to Figure
  2. Reducing Agent Injector -N474-
  3. NOx Sensor Control Module 2 -J881- and NOx Sensor 2 -G687-
  4. NOx Sensor Control Module -J583- with NOx Sensor -G295-
  5. Reducing Agent Metering System Control Module -J880-
    • Only installed on vehicles with a SCR catalytic converter
  6. Exhaust Gas Temperature Sensor 4 -G648-
  7. Exhaust Gas Temperature Sensor 2 -G448-
  8. Particulate Sensor -G784-