Exhaust Pipes/Mufflers, Separating: Procedure
WARNING: This page is about a different car, the 2016 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Separate the exhaust pipes at a right angle at the separating points -arrow- using a : VAS6254 .
-- When installing, position the clamping sleeves -arrows- on the center of the separating point
-- Install double clamps so that the bolt ends do not project over lower edge of double clamp.
- Installed position: the threaded connectors face forward.
-- Install the exhaust system free of tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .