EGR Temperature Sensor -G98-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2016 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the Intake Flap Motor -V157-. Refer to Intake Flap Motor -V157-, REMOVING AND INSTALLING .
-- Remove the bolts -arrows- and then press the bracket -2- and the EGR Cooler Switch-Over Valve -N345- -1- to the side.
-- Remove the connector -1- from the bracket, disconnect it and free up the wire.
-- Remove the EGR Temperature Sensor -G98- -2-.