EGR Cooler, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals and O-rings.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Install the intake manifold. Refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .

NOTE:

Do not reuse used coolant.

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING => Filling .