Secondary Air Injection Pump Motor -V101-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front left wheel. .

-- Remove the left front wheel housing liner. Refer to WHEEL HOUSING LINER . .

-- Remove the air filter -2- from the mount in direction of -arrow-.

GWWA10-11554

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore item -1-.

Audi RS6/RS7

GWWA19-11778

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Use a cloth to catch any leaking coolant.

-- Remove the nut -3- and free up the coolant hose.

-- Clamp off the coolant hose -1- with the :3094 .

-- Loosen the hose clamp -2- to clamp off the coolant hose with :3094 and remove.

Continuation For All Vehicles

GWWA26-11253

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

-- Remove the connector -3- from the bracket and disconnect it.

GWWA26-11249

Courtesy of AUDI OF AMERICA, LLC

-- Press the release buttons and remove the secondary air hose -2-.

NOTE:

Ignore item -1-.

-- Press the release buttons -3- to remove the resonator with the air filter.

GWWA26-11254

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and the nut -2- and then press the Secondary Air Injection Pump Motor -V101- and the mount slightly to the side.

-- Remove the nuts -arrows- and the secondary air pump.