Exhaust Pipes/Mufflers, Separating: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
-- Separate the exhaust pipes at a right angle at the separating points -arrow- using a :VAS6254 .
-- When installing, position the clamping sleeves -arrows- on the center of the separating point
-- Install double clamps so that the bolt ends do not project over lower edge of double clamp.
- Installed position: Threaded connections point forward.
-- Install the exhaust system free of tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .