LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Engine System (Assembly - Service Information - TDI 3.0L - CPNB)) >> Engine Assembly >> SUBFRAME Mount >> Overview - SUBFRAME Mount >> Engine Mount

Engine Mount

WARNING: This page is about a different car, the 2016 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Mount Exploded View
GWWA10-10803Courtesy of AUDI OF AMERICA, LLC
  1. Bolt
    • 20 Nm
  2. Retaining Plate
    • For the engine mount
    • If the engine mount is faulty, replace the retaining plate
    • Check the retaining plate on the opposite side; replace if necessary
  3. Bolt
    • 40 Nm
  4. Engine Support
  5. Bolt
    • 10 Nm
  6. Heat Shield
  7. Bolt
    • 90 Nm + 90°
    • Always replace
  8. Engine Mount
    • Left with the Left Electrohydraulic Engine Mount Solenoid Valve -N144-
    • Right with the Right Electrohydraulic Engine Mount Solenoid Valve -N145-
    • Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
  9. Subframe
    • There are different versions. For the correct allocation. Refer to the Parts information.
  10. Bolt
    • 55 Nm
scientia non olet · About LEMON Manuals