SUBFRAME Mount Sensor, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front noise insulation. Refer to NOISE INSULATION . .
Subframe Mount Sensor 2 -G749- (left side)
-- Remove the rear noise insulation. Refer to NOISE INSULATION . .
-- Remove the front left wheel spoiler. Refer to WHEEL HOUSING LINER . .
-- Audi RS6/RS7: Remove the nut -arrow- and free up the coolant line -1-.
-- Loosen bolt -2- and remove the bolts -1 and 3-.
-- Left lower coolant hose push aside.
NOTE:
Ignore the -arrows-.
Continued for Both Sides
-- Disconnect the connector -1-.
NOTE:
The :T10405 is required for the left side of the vehicle.
-- Remove the bolt -2- and remove the subframe mount sensor.