Right Engine Mount, Removing And Installing: Removing

-- Disconnect the ground cable from the battery terminal. Refer to BATTERY . .

-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLED POSITION .

-- Remove the right front wheel. Refer to WHEELS/TIRES/TIRE PRESSURE MONITORING ASSEMBLY . .

-- Remove the front left and right wheel housing liners. Refer to WHEEL HOUSING LINER . .

-- Remove the left and right front wheel spoiler. Refer to WHEEL HOUSING LINER . .

-- Remove the oil filter element.

-- Remove the nuts -arrows- and lower the stabilizer bar.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -2- and push the ground wire aside.

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wire from the right engine support.

-- Remove the connector -arrow- from the mount, disconnect it, and then guide it through the subframe.

Courtesy of AUDI OF AMERICA, LLC

Audi S6/S7 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right nut -1- and remove the bracket with the wiring harness from the subframe.

Audi RS6/RS7 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right bolt -arrow-, free up the bracket with the wiring harness.

Continuation for All Vehicles 

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -2 and 3- and free up the wires.

-- Remove the left and right bolts -1-.

-- Remove the bolts -arrows-.

-- Lift the engine using the :10-222A/11  -1- to dimension -a-.

Courtesy of AUDI OF AMERICA, LLC

• Dimension -a- = approximately 20 mm.

-- Remove the retaining plate for the engine mount and the right engine mount.