Connection Diagram - Coolant Hose, AUDI S6/S7 With A Parking Heater
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Radiator for the Charged Air Coolant Circuit
- Radiator
- Check Valve
- Charge Air Cooler
- Engine Oil Cooler
- Coolant Shut-Off Valve
- Activated by the Cylinder Head Coolant Valve -N489-
- Engine Coolant Temperature Sensor -G62-
- Engine Temperature Control Sensor -G694-
- Generator
- Cylinder Head
- For cylinder bank 1 (right)
- Recirculation Pump -V55-
- Not available in North America.
- Parking Heater
- Not available in North America.
- Heater Coolant Shut-Off Valve -N279-
- Not available in North America.
- Heater Core for Heater
- Removing and installing. Refer to FRONT HEATER AND A/C UNIT . .
- Bleed Screw
- ATF Cooler
- Removing and installing. Refer to TRANSMISSION, REMOVING AND INSTALLING . .
- Turbocharger
- For cylinder bank 1 (right)
- Turbocharger
- For cylinder bank 2 (left)
- Engine Coolant Circulation Pump 2 -V178-
- Cylinder Head
- Cylinder bank 2 (left)
- Coolant Pump
- Cap
- Checking the pressure relief valve. Refer to PRESSURE RELIEF VALVE IN CAP, CHECKING .
- Coolant Reservoir
- Map Controlled Engine Cooling Thermostat -F265-
- Transmission Fluid Cooling Valve -N509-
- After-Run Coolant Pump -V51-
- For Radiator Coolant Circuit for ATF Cooling
- Charge Air Cooling Pump -V188-
- Engine Coolant Temperature Sensor on Radiator Outlet -G83-