Connection Diagram - Coolant Hose, AUDI RS6/RS7
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Radiator for the Charged Air Coolant Circuit
- Radiator
- Check Valve
- Charge Air Cooler
- Right Auxiliary Cooler
- Coolant Thermostat
- For right auxiliary cooler
- Engine Oil Cooler
- Engine Temperature Control Sensor -G694-
- Generator
- Engine Coolant Temperature Sensor -G62-
- Coolant Shut-Off Valve
- Activated by the Cylinder Head Coolant Valve -N489-
- Cylinder Head
- For cylinder bank 1 (right)
- Coolant Recirculation Pump -V50-
- Bleed Screw
- Heater Core for Heater
- Removing and installing. Refer to FRONT HEATER AND A/C UNIT . .
- Gear Oil Cooler
- ATF Cooler
- Removing and installing. Refer to TRANSMISSION, REMOVING AND INSTALLING .. .
- Turbocharger
- For cylinder bank 1 (right)
- Turbocharger
- For cylinder bank 2 (left)
- Transmission Fluid Cooling Valve -N509-
- Engine Coolant Circulation Pump 2 -V178-
- Cylinder Head
- Cylinder bank 2 (left)
- Coolant Pump
- Cap
- Checking the pressure relief valve. Refer to PRESSURE RELIEF VALVE IN CAP, CHECKING .
- Coolant Reservoir
- Map Controlled Engine Cooling Thermostat -F265-
- Rear Radiator Coolant Circuit for ATF Cooling
- After-Run Coolant Pump -V51-
- Front Radiator Coolant Circuit for ATF Cooling
- Charge Air Cooling Pump -V188-
- Engine Coolant Temperature Sensor on Radiator Outlet -G83-
- Bleed Screw