Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .
-- If equipped remove the lower front left longitudinal member. Refer to WHEEL HOUSING LINER . .
-- Disconnect the connector -3-.
-- Open the clamp -1- and remove the coolant hose.
NOTE:
Ignore item -2-.
-- Disconnect the connector -1-.
-- Remove the bolts -arrows-.
-- Loosen the hose clamp -3- to remove the coolant hose from the Map Controlled Engine Cooling Thermostat -F265-.