LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Engine Cooling System (Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC)) >> 19 Cooling System >> Coolant Pump/Thermostat >> Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING >> Installing

Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seal.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Connect the coolant hose to the coupling. Refer to Figure.

NOTE:

Do not reuse used coolant.

-- Fill with coolant. Refer to FILLING .

scientia non olet · About LEMON Manuals