Engine Coolant Temperature Sensor -G62 - / Engine Temperature Control Sensor -G694-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Audi S6/RS6/RS7

-- Remove the radiator, with the fan shroud. Refer to RADIATOR, REMOVING AND INSTALLING, AUDI S6/S7 .

Audi S7

Courtesy of AUDI OF AMERICA, LLC

-- Remove the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .

Engine Coolant Temperature Sensor -G62-:

-- Disconnect the connector -1-.

NOTE:

Use a cloth to catch any leaking coolant.

-- Remove the bolt -2-, and remove the Engine Coolant Temperature Sensor -G62-.

NOTE:

If an O-ring remains in the cylinder block, remove the O-ring with a wire.

Engine Temperature Control Sensor -G694-:

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

NOTE:

Use a cloth to catch any leaking coolant.

-- Remove the bolt -1- and remove the Engine Temperature Control Sensor -G694-.

NOTE:

If an O-ring remains in the cylinder block, remove the O-ring with a wire.