LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Engine Cooling System (Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC)) >> 19 Cooling System >> Coolant Pump/Thermostat >> Engine Coolant Temperature Sensor -G62 - / Engine Temperature Control Sensor -G694-, REMOVING AND INSTALLING >> Installing

Engine Coolant Temperature Sensor -G62 - / Engine Temperature Control Sensor -G694-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the O-rings.

Audi S6/RS6/RS7 

-- Install the radiator, with the fan shroud. Refer to RADIATOR, REMOVING AND INSTALLING, AUDI S6/S7 .

Audi S7 

-- Install the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .

Continuation For All Vehicles 

-- Check the coolant level. Refer to CHECK THE COOLANT LEVEL .

scientia non olet · About LEMON Manuals