Lower Front Coolant Lines, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front noise insulation. Refer to NOISE INSULATION . .

-- Remove the lower front right longitudinal member. Refer to LOCK CARRIER . .

-- Remove the front bumper cover end plate. Refer to FRONT BUMPER . .

-- Remove the nut -arrow- and free up the coolant line -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Place the :VAS6208 under separating point.

-- Remove the clamp -1- and loosen hose clamp -3- to disconnect the coolant hose and drain the coolant.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -4- and remove the supports from the coolant pump.

-- Loosen hose clamp -arrow-, remove the front and right coolant lines.