Supercharger, Securing To Engine/Transmission Holder For Repair Work
NOTE:
The openings on the bottom of the supercharger housing should make it possible to see and reach the charge air cooler.
Special Tools And Workshop Equipment Required
- Engine and Gearbox Bracket :VAS6095A
- Gearbox Support :T40206 with Gearbox Support 1 :T40206/1
- Supercharger Module Support :T40304
- Supercharger removed. Refer to SUPERCHARGER, REMOVING AND INSTALLING .
-- Insert the :T40206 with :T40206/1 in the :VAS6095A .
-- Install the :T40304 next loosely on the :T40206/1 while doing so pay attention to the allocation of the holes -1, 3, 10 and 12- on the mount and the :T40206 .
-- Place the supercharger on the :T40304 as shown in the illustration.
- It is possible to see and reach the charge air cooler through the openings on the bottom inside the supercharger housing.
-- Tighten the bolts -1- evenly on the left and the right diagonally hand-tight.
-- Tighten the :T40304 to 21 Nm on the :T40206/1 .
-- Tighten the left and right bolts -1- diagonally to 21 Nm.