Input Shaft Seal, Replacing

Special Tools And Workshop Equipment Required 

• Bearing/Bushing Installer - Multiple Use :VW295 
• Bearing Installer - Wheel Bearing :3144 
• Plate :T40285 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the operating head. Refer to OPERATING HEAD, REMOVING AND INSTALLING .

-- Place the operating head with the front side upward on the Plate:T40285  as shown in the illustration.

-- Drive out the seal from the operating head using the :VW295  .

-- Place the operating head with the front side downward on the workbench.

-- Drive in the gasket with the :3144  .

• Installation position: the open side of the gasket points to the tool.

  Courtesy of AUDI OF AMERICA, LLC

-- Install the operating head. Refer to OPERATING HEAD, REMOVING AND INSTALLING .