Overview - SUBFRAME Mount

Fig 1: Transmission Subframe Mount Components Location

Courtesy of AUDI OF AMERICA, LLC

Bolt
- M10x55 8.8: 40 Nm
- M10x40 10.9: 70 Nm
Tunnel Crossmember
- Removing and installing. Refer to TUNNEL CROSSMEMBER, REMOVING AND INSTALLING .
Stop
- For the transmission mount
Transmission Mount
- Removing and installing. Refer to SUBFRAME MOUNT [For engine(s) CYNB] or SUBFRAME MOUNT [For engine(s) CREC, CREH] or SUBFRAME MOUNT [For engine(s) CTGE, CEUC] or SUBFRAME MOUNT [For engine(s) CPNB] .
Bolt
- 40 Nm
Nut
- 20 Nm
- Only remove when the transmission mount must be separated from the transmission support
Bolt
- 40 Nm
Transmission Support
- Removing and installing. Refer to SUBFRAME MOUNT [For engine(s) CYNB] or SUBFRAME MOUNT [For engine(s) CREC, CREH] or SUBFRAME MOUNT [For engine(s) CTGE, CEUC] or SUBFRAME MOUNT [For engine(s) CPNB] .
Bolt
- 20 Nm +90° turn
- Always replace
- Only remove when the transmission mount must be separated from the transmission support
Nut
- 20 Nm