Coolant Fan Control Module, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the front noise insulation. Refer to FRONT NOISE INSULATION, REMOVING AND INSTALLING .
WARNING:
There Is A Risk Of Injury If The Radiator Fan Turns On By Itself.
- Disconnect the connectors before working near the fan shroud.
-- Remove the coolant fan connector -1- from the bracket and disconnect it by sliding the retainer back in direction of -arrow- and pressing the release down.
-- Free up the electrical wiring harness to the coolant fan control module.
-- Disconnect the connectors -2 and 3-.
-- Remove the bolt -arrow- and the coolant fan control module -1-.