LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A6 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Cooling System (Service Information - CYNB - 1 Of 2)) >> 19 Cooling System >> Coolant Pump/Thermostat >> Coolant Valves, Removing And Installing >> Transmission Coolant Valve -N488-, Removing And Installing >> Removing

Transmission Coolant Valve -N488-, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove The Noise Insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

GWWA19-11641Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -1-, then clamp off the coolant hoses with the :3094  and then remove them.

-- Remove the nuts -arrows- and then remove the Transmission Coolant Valve -N488-.

scientia non olet · About LEMON Manuals